Stud Center Finding Sensor, Multi- Scanner Wood, Metal and AC Live Wire Detector with LCD Display, Deep Scanning Kuled

Category: Misc.
Store Name: KULED
Brand: KULED
KULED Stud Finder is a easy-to-use, also a necessary tool that quickly and easily locates the center of wood and metal studs and joists behind walls, floors, and ceilings etc.
This stud finder operates by slowly slide device horizontally across wall, right of left. When full bars appears on the LCD and steady tone sounds, you have located the center of stud.

- STUD mode: detect metal and wood studs up to 0.75 inches (19mm) .
- METAL mode: detect metal pipes ,rebars etc up to 2.3 inches (60mm) .
- DEEP mode: detects wooden beams ,metal rebars up to 1.5 inches (38mm) .
- AC mode: detects AC live wire up to 2 inches (51mm) . Select AC scan mode to determine
position of hot wires. Begin by placing the scanner at some position away from hot wiring.
- Auto power off after about 1 minutes of non-use.
- Low battery indicator
- Auto calibration all functions detection
- Battery :1x9V battery(include)

How to use
1: Press ON/OFF button to power on the device, and press RIGHT button to choose the scanning
mode you want to detect. Listen "beep"to confirm the mode button effective.
2: Place the device flat on wall first. Then press and hold the button at the left side of the device ,
and keep the unit still until the unit sound a short beep twice and the display bars will be
cleared .
3: While still holding on the button ,move the stud finder on the desired surface to scan and
detect for studs, metal beams, rebars, pipes ,AC wire etc .you can scan the object from left to
4 : When the device detected an object , it will beep continually and a peck shape will also display
on the LCD screen .

Battery installation
1.Open battery door on back of case.
2.Connect a 9-volt battery to battery clip.
3.Insert battery into case and replace battery door.

Package Contents
1 x Stud Finder
1 x 9V battery (included)
1 x User Manual
  • Stud sensor scanner depth: detects stud up to 0.75 inches (19mm), metal up to 2.36 inches (60mm), deep Scanning up to 1.5 inches (38mm), presence of live wire up to 2 inches (51mm)
  • 3 in 1: multi-scanner stud finder for wood, metal, deep, AC current. Quickly locates edges and center of wood, wall studs, metal pipes, wooden joist, rebar behind walls, floors and ceilings, also indicates the presence of live AC wire
  • Easy to read: LCD with digital display and continuous sound warning indicating you the location of the edges of the studs
  • Easy to use: only three buttons, first press on/off button, then select the probe Type, after that just press and hold the "scan button"(at the left side of the device) and scan horizontally across the object surface. Auto power off without any operation after 60 seconds
  • Compact design is easy to hold and use. Low battery indication. Battery: 1x9V battery(included)suring tools, layout tools, stud finder wallscanner, wallmount
Height0.01 inches
Length 0.06 inches
Weight0 pounds
Width 0.02 inches
Height0.0197 inches
Length 0.074 inches
Weight0.005 pounds
Width 0.0331 inches

Other Products